1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. If you are going to register on XLNation, please make sure you do not use a proxy server.
    If you use a proxy server your registration will most likely get blocked due to spammers and hackers using proxy servers to hide their real IP address.

    If your using your home or work IP address and have not received your registration email, check your spam folder.
    PLEASE DO NOT ASK TO HAVE YOUR ACCOUNT DELETED IF YOU HAVE POSTED IN THE FORUM! If so we do not delete accounts due to the mess it can make on the forum.
    Dismiss Notice
Cookies New Members

Tutorials Lod 1 To Lod 4 Projection Mapping 1.0

LOD 1 To LOD 4 Projection Mapping

  1. nicko2u

    nicko2u Governor

    Joined:
    Aug 22, 2014
    Messages:
    742
    Likes Received:
    1,108
  2. nicko2u

    nicko2u Governor

    Joined:
    Aug 22, 2014
    Messages:
    742
    Likes Received:
    1,108
    Add your Tips/solutions here if found problems when following the basic tutorial. Also any other comments about this tut welcomed.

    If you get strange results when rendering the maps, it can be a few things causing this.

    Tip: First one I usually check is make sure the target map slot is set correct. I.E if you select a map slot make sure its either the diffuse or illumination slot.

    Tip: Adjust the Projection offset value. If your L1 & L4 geometry is very close to each other add a lower value else add a higher value. This can take a few renders to get correct. Enable RayMiss to debug, the missing textures should show in red on the map.
     
  3. nicko2u

    nicko2u Governor

    Joined:
    Aug 22, 2014
    Messages:
    742
    Likes Received:
    1,108
  4. nicko2u

    nicko2u Governor

    Joined:
    Aug 22, 2014
    Messages:
    742
    Likes Received:
    1,108
(You must log in or sign up to post here.)

Share This Page